HEADPHONE AMPLIFIER HA-1 USER MANUAL USBMade for
6 end of the remote control and push. The battery tray will pop slightly open. Pull out the battery tray with the remote control buttons facing down
7 Headphone Output Connection You can connect your headphones to the OPPO HA-1 using either a standard 6.35 mm connector or a 4-pin XLR balanced con
8 jacks. The output level is controlled by the Volume Knob or remote. The output is not muted when a pair of headphones is plugged in. It is muted w
9 Input Signal Connections The OPPO HA-1 supports multiple analog and digital input connections. Depending on your intended usage, please connect on
10 Optical Digital Audio Input You can connect a device with an optical digital output into the Optical Digital Audio Input of the HA-1 using an opt
11 Note: Depending on the operating system and playback software used, driver software, specific software settings and configurations may be req
12 Notes: Bluetooth technology works with iPhone 5S, iPhone 5C, iPhone 5, iPhone 4S, iPad (4th generation), iPad mini, and iPod touch (5th gener
13 Using the OPPO HA-1 Basic Operations Power On / Off When the HA-1 is initially connected to AC power, it stays in standby mode. Pressing the Powe
14 Remote: You can also switch input sources by directly pressing the appropriate source button on the remote. Volume Control Rotating the Volu
15 Remote: For those who use the HA-1 as both a headphone amplifier and a pre-amplifier, it is possible to assign the MUTE button to the Pre-ampl
16 The following configuration screens are available: Home Screen Selection You can choose one of three screens to be the Home Screen for your HA-1.
17 Mute All (default) – Both the Headphone Jack and Pre-amplifier Output are muted when the MUTE button is pressed. This condition is indicated b
18 Home Theater Bypass Mode Each of the HA-1’s input sources can be individually configured to operate in a Home Theater Bypass mode. If an input so
19 It is important to configure an input source in Home Theater Bypass mode only if the connected device has its own volume control. Do not connect
20 The input sources that are in Home Theater Bypass mode are indicated with a “BYPASS” banner in the Source Selection screen. Reset Factory Defau
21 Reference Usage Notes In order to prolong the life of your headphone amplifier, it is recommended that you wait at least 30 seconds before you
22 Specifications Designs and specifications are subject to change without notice. General Dimensions (W x H x D)
23 DAC Performance Specifications Specification XLR Output RCA Output Output Level 4.6 ± 0.3 Vrms 2.3 ± 0.3 Vrms Frequency Response (Tested with
© 2014 OPPO 51979368 V 1.1
i Table of Contents Important Information ...
ii Power On / Off ...
1 Important Information The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of
2 Precautions Before connecting the AC power cord to the appliance, make sure the voltage designation of the appliance corresponds to the local e
3 Introduction The HA-1 Headphone Amplifier draws upon the proven circuit design of the BDP-95 and BDP-105 Blu-ray Disc players. We designed the HA-
4 Installation Front Panel Controls 1. Power Button 2. Power Status Indicator 3. 6.35 mm Headphone Jack 4. Source Selector Knob 5. Balanced He
5 Remote Control Remote Control Buttons POWER: Toggle between STANDBY and ON MUTE: Mute audio output VOLUME +/-: Increase and decrease volume PREV:
Kommentare zu diesen Handbüchern